Surfaces, Coatings and Films, General Materials Science, Materials Science, Mechanics of Materials
1
Scopus Publications
19
Scholar Citations
1
Scholar h-index
1
Scholar i10-index
Scopus Publications
A comparative study of thermal sprayed Al2O3-TiO2 coatings on PM AISI 316L Kenan Tankal, Bekir Güney, Mehmet Akif Erden Engineering Science and Technology an International Journal, 2024 The widespread use of stainless steels (SS) in various applications is hindered by their inadequate wear resistance, hardness and high density. Structural metallic components fabricated via powder metallurgy (PM) exhibit lower densities compared to those produced by conventional methods due to their inherent high porosity. However, this compromises their mechanical and corrosion performance. This study has investigated the application of pure Al 2 O 3 and Al 2 O 3 + 13 %TiO2 powders with varying particle sizes on PM AISI 316L substrates to enhance their mechanical and wear properties. The phase composition, microhardness, coating morphology, surface roughness, porosity and wear rate of coated and uncoated samples were comparatively analysed to elucidate the influence of both TiO 2 addition and coating powder particle size on the mechanical properties and surface morphology of the samples. Microstructural and XRD studies confirmed good mechanical and metallurgical bonding of the coatings to the substrate. All of the coated samples exhibited 24 to 34 times higher surface roughness and 1.3 to 2.1 times lower porosity values compared to the substrate. The finer sized TiO 2 added alumina-based coating powder reduced the surface roughness and porosity value to 1.8 and 1.4 times respectively while the use of the coarser sized one reduced these values to 1.3 and 1.2 times respectively compared to the pure Al 2 O 3 coated surface. 8-times higher hardness and 70-times lower wear rate values compared to the substrate were the most significant improvements observed in the pure Al 2 O 3 coated surface among all coated samples. Although TiO 2 addition to the coating powder decreased hardness by 1.1 times and increased wear rate by 1.8 times, spraying finer TiO 2 added coating powders resulted in a slight improvement in both hardness and wear resistance compared to the coarser one.
RECENT SCHOLAR PUBLICATIONS
Investigation of Corrosion Properties of Stainless Steel Produced by Powder Metallurgy Coated with Thermal Spray Technique K TANKAL, B GÜNEY, MA ERDEN 2025
A comparative study of thermal sprayed Al2O3-TiO2 coatings on PM AISI 316L K Tankal, B Güney, MA Erden Engineering Science and Technology, an International Journal 60, 101895 , 2024 2024 Citations: 19
MOST CITED SCHOLAR PUBLICATIONS
A comparative study of thermal sprayed Al2O3-TiO2 coatings on PM AISI 316L K Tankal, B Güney, MA Erden Engineering Science and Technology, an International Journal 60, 101895 , 2024 2024 Citations: 19
Investigation of Corrosion Properties of Stainless Steel Produced by Powder Metallurgy Coated with Thermal Spray Technique K TANKAL, B GÜNEY, MA ERDEN 2025
