Jose Alexandre Matelli

Scopus Publications

Advancing Artificial Intelligence with a Systematic Review of Neuro-Symbolic Systems
Blaha Gregory Correia dos Santos Goussain, Roque Antônio de Moura, José Alexandre Matelli
International Conference on Artificial Intelligence Computer Data Sciences and Applications Acdsa 2026, 2026
Resilience in cogeneration systems: Graphical analysis of novel indexes and system behavior under failure scenarios
Fellipe Sartori da Silva, Thiago Magalhães Lessa, José Alexandre Matelli
International Journal of Critical Infrastructure Protection, 2025
Fuzzy Soft Skills Assessment through Active Learning Sessions
André Seixas de Novais, José Alexandre Matelli, Messias Borges Silva
International Journal of Artificial Intelligence in Education, 2024
Experimental correlation for external forced convection in non-standardized finned tubes perpendicular to the flow
Rodrigo Ducatti Marson, Alex Mendonça Bimbato, José Alexandre Matelli
Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2024
Energy Resilience: Definition and Assessment
Sartori da Silva Fellipe, José Alexandre Matelli
Power Systems, 2024
A Fuzzy Inference System for Detection of Positive Displacement Motor (PDM) Stalls during Coiled Tubing Operations
Rafael Augusto Galo Fernandes, Paloma Maria Silva Rocha Rizol, Andreas Nascimento, José Alexandre Matelli
Applied Sciences Switzerland, 2022
Positive Displacement Motors (PDM) are extensively used in the oilfield, either in drilling or in coiled tubing (CT) operations. They provide a higher rate of penetration and the possibility of drilling horizontal wells. For coiled tubing operations, PDMs can mill through obstructions and enable shut-in wells to work again. One of the major challenges while using these tools is the motor stalling, which can lead to serious damage to the PDM and lost time events in drilling and workover rigs. These events result in total losses of hundreds of thousands of dollars, and their avoidance mostly depends on trained and fully aware equipment operators. If a PDM starts to stall, the pumping needs to be halted immediately or the tool may fail. This paper describes the use of a Fuzzy Inference System (FIS) to detect the stalling events as they start to happen using the acquisition data from the coiled tubing unit, the output of the FIS could then trigger an alarm for the operator to take the proper action or remotely stop the pump. The FIS was implemented in Python and tested with real CT milling acquisition data. When tested using real data, the system analyzed 68,458 acquisition points and detected 94% of the stalling events across this data during its first seconds, whereas, during the real job, a CT operator could take longer to notice this event and take the proper action, or even take no action. If the FIS was applied on a real coiled tubing acquisition system, it could reduce PDMs over-pressurization due to stalling, leading to an increase on its useful life and decrease on premature failure. As of now there is no similar system in the market or published and this kind of operation is fully performed using human supervision only.
Corrigendum to ‘Script for resilience analysis in energy systems: Python programming code and partial associated data of four cogeneration plants’ [Data in Brief 36 (2021) 106986] (Data in Brief (2021) 36, (S2352340921002705), (10.1016/j.dib.2021.106986))
Fellipe Sartori da Silva, José Alexandre Matelli
Data in Brief, 2022
Resilience in cogeneration systems: Metrics for evaluation and influence of design aspects
Fellipe Sartori da Silva, José Alexandre Matelli
Reliability Engineering and System Safety, 2021
Script for resilience analysis in energy systems: Python programming code and partial associated data of four cogeneration plants
Fellipe Sartori da Silva, José Alexandre Matelli
Data in Brief, 2021
Energy education: Reflections over the last fifteen years
Rubens Alves Dias, Marília Rios de Paula, Paloma Maria Silva Rocha Rizol, José Alexandre Matelli, Cristiano Rodrigues de Mattos, et al.
Renewable and Sustainable Energy Reviews, 2021
Applications of compressed air energy storage in cogeneration systems
Felipe Seabra Vieira, José Antonio Perrella Balestieri, José Alexandre Matelli
Energy, 2021
Energy efficiency in Brazilian industrial plants: knowledge management and applications through an expert system
Gilberto Paschoal Buccieri, José Antonio Perrella Balestieri, José Alexandre Matelli
Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2020
Expert systems and knowledge management for failure prediction to onshore pipelines: Issue to industry 4.0 implementation
Gilberto Pachoal Buccieri, Jorge Muniz Jr., José Antonio Perrella Balestieri, José Alexandre Matelli
Gestao E Producao, 2020
Development of metrics for resilience quantification in energy systems
Fellipe Sartori Da Silva, José Alexandre Matelli
Proceedings of the Annual Conference of the Prognostics and Health Management Society Phm, 2019
Exergoeconomic analysis and determination of power cost in MCFC – steam turbine combined cycle
Fellipe Sartori da Silva, José A. Matelli
International Journal of Hydrogen Energy, 2019
Resilience evaluation of the environmental control and life support system of a spacecraft for deep space travel
José Alexandre Matelli, Kai Goebel
Acta Astronautica, 2018
Conceptual design of cogeneration plants under a resilient design perspective: Resilience metrics and case study
José Alexandre Matelli, Kai Goebel
Applied Energy, 2018
Direct ethanol fuel cell as aircraft APU: a study for onboard waste heat recovery
Marcelo de Almeida Ramsdorf, José Alexandre Matelli
Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2018
Heat recovery of dedusting systems in electric arc furnaces: concept of a bottoming cogeneration plant and techno-economic analysis
Cesar Augusto Arezo e Silva, José Alexandre Matelli
Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2018
Carbon exergy tax applied to biomass integrated gasification combined cycle in sugarcane industry
Valdi Freire da Fonseca Filho, José Alexandre Matelli, José Antonio Perrella Balestieri
Energy, 2016
Conceptual design of biomass-fired cogeneration plant through a knowledge-based system
José Alexandre Matelli
Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2016
Cogeneration design problem Computational complexity analysis and solution through an expert system
José Alexandre Matelli, Jonny C. Silva, Edson Bazzo
Engineering Computations Swansea Wales, 2014
Development of a knowledge-based system for cogeneration plant design: Verification, validation and lessons learned
Jonny Carlos da Silva, José Alexandre Matelli, Edson Bazzo
Knowledge Based Systems, 2014
On the parameters of performance of combined refrigeration and power plants
José Alexandre Matelli, Edson Bazzo
International Journal of Refrigeration, 2013
Experimental results and thermodynamic analysis of a natural gas small scale cogeneration plant for power and refrigeration purposes
Edson Bazzo, Alvaro Nacif de Carvalho, José Alexandre Matelli
Applied Thermal Engineering, 2013
Development of a case-based reasoning prototype for cogeneration plant design
José Alexandre Matelli, Edson Bazzo, Jonny Carlos da Silva
Applied Energy, 2011
An expert system prototype for designing natural gas cogeneration plants
José Alexandre Matelli, Edson Bazzo, Jonny Carlos da Silva
Expert Systems with Applications, 2009
A case-based reasoning prototype for cogeneration plant design
ECOS 2009 22nd International Conference on Efficiency Cost Optimization Simulation and Environmental Impact of Energy Systems, 2009
On the parameters of performance of combined cooling and power plants
ECOS 2007 Proceedings of the 20th International Conference on Efficiency Cost Optimization Simulation and Environmental Impact of Energy Systems, 2007
An experimental investigation of an ammonia/water absorption system associated to a microturbine
ECOS 2007 Proceedings of the 20th International Conference on Efficiency Cost Optimization Simulation and Environmental Impact of Energy Systems, 2007
An expert system initial prototype for natural gas cogeneration systems design and optimization
ECOS 2006 Proceedings of the 19th International Conference on Efficiency Cost Optimization Simulation and Environmental Impact of Energy Systems, 2006
A methodology for thermodynamic simulation of high temperature, internal reforming fuel cell systems
José Alexandre Matelli, Edson Bazzo
Journal of Power Sources, 2005

Jose Alexandre Matelli

RESEARCH, TEACHING, or OTHER INTERESTS

Scopus Publications